
Hydraulic Submersible Pump Stanley SM50

The SM50 Hydraulic Submersible Water Pump is a centrifugal type pump that requires no priming. The motor is contaminant-tolerant gear motor uniquely designed for continuous highspeed operation. The motor drives the impeller directly, so there are no spindle bearings that require periodic lubrication or replacement. The cast stainless steel, semi-closed impeller resists corrosion. A series of seals on the drive shaft effectively keep hydraulic fluid and pumped water where they belong while allowing the pump to be run dry without sudden seal failure.
The water outlet is 3-inch pipe thread fitted with a 3-inch groove fitting to which can be connected a cam hose end fitting.
The SM50 can draw down water to a depth of 3.5 inches. Putting the SM50 in a sump will allow it to pump all but 3.5 inches of water remaining in the sump.
The integral screen effectively keeps solids larger than 3/8 of an inch out of the pump. The pump will handle clear water and water containing up to 10% solids.
Features:
(+) 7-12 gpm (26-45 lpm) operating range
(+) Submersible (no priming required)
(+) Able to run dry without damage
(+) 3/8 inch strainers
(+) Lifting eyes


|
 |
SM50 |
TECHNICAL SPECIFICATIONS
Discharge |
3" |
Performance |
1890 lpm |
Hydraulic Flow |
26-45 lpm
|
Hydraulic Pressure |
70-140 bar |
Weight |
9,5 kg |
Length |
27 cm |
Width |
26 cm |
Couplers |
HTMA Flush Face |

GPV13

TP03

CS06
|
PARAGON: Hydraulic Submersible Pump Stanley SM50
NOTICE: Written and visual materials on this page cannot be copied, quoted or used in other media without permission. Technical specifications are for general information purposes only. It may vary in final products according to sub-models. If these features are critical to your field applications, please contact PARAGON. Paragon Contact |
|
|